The Trident Cycle Supply Breadbox Air Cleaner is the same size as the original stamped steel air cleaners from years ago but slimmed down to 1.375". The cover and backing plate are machined from 6061 aluminum and the filter is made up of 2 stainless steel cages that hold a piece of Uni Filter foam in between. Hardware to mount the air cleaner to your carb is included.
These air cleaners are available for S&S Super E/G and HD CV carburetors. The CV backing plates have the S&S holes spot drilled and vice versa to make it easy for you switch carbs. Exact measurements are 7" x 4.375" x 1.375".
***Don't forget to grab a CV carb support bracket!!! CV carbs need to be supported to properly seal. You will also need a breather setup for any head breather Evo***
Replacement foam is available.
Finishes
Tumbled finish - plates are run through a vibratory tumbler with ceramic media, this leaves a dull aluminum finish, somewhat similar to a raw cast finish.
Polished finish - flat polished aluminum surfaces seem to show small scratches and haziness easier than uneven surfaces, please keep that in mind, these are rarely "perfect".
Chrome finish - in my opinion these look the best, mirror finish that you don't really need to worry about scratching. The shop I use plates these down in TJ, they are usually a 9.5/10 when I get them, please keep that in mind.
Patina finish - plates are sprayed with an acid solution that darkens them, they are then finished with steel wool. These will always vary, if there is a certain look you are after I can tell you what stuff to buy to do it yourself.
