The Trident Cycle Supply Breadbox Air Cleaner is the same size as the original stamped steel air cleaners from years ago but slimmed down to 1.375". The cover and backing plate are machined from 6061 aluminum and the filter is made up of 2 stainless steel cages that hold a piece of Uni Filter foam in between. Hardware to mount the air cleaner to your carb is included. 

These air cleaners are available for S&S Super E/G and HD CV carburetors. The CV backing plates have the S&S holes spot drilled and vice versa to make it easy for you switch carbs. Exact measurements are 7" x 4.375" x 1.375".

Replacement foam is available.

***Don't forget to grab a CV carb support bracket!!! CV carbs need to be supported to properly seal. You will also need a breather setup for any head breather Evo***

Finishes

Tumbled finish - plates are run through a vibratory tumbler with ceramic media, this leaves a dull aluminum finish, somewhat similar to a raw cast finish.

Patina finish - plates are sprayed with an acid solution that darkens them, they are then finished with steel wool. These will always vary, if there is a certain look you are after I can tell you what stuff to buy to do it yourself.

OFF-ROAD / SHOW USE ONLY: Products are intended for off-road, racing, competition, show, or exhibition use unless otherwise stated. Products are not represented as DOT approved or street legal. Buyer is responsible for determining legality, compatibility, proper installation, and safe use. Please see full terms and conditions for more detail.